Quasar 3D Delta
Link to Build Instructions coming soon
The Quasar 3D Delta is a great all around flyer and by far one of our fastest as well as easiest builds. This airframe was designed as an indoor flyer and is made from our custom hot wired 7.5 mm 1.3lb EPP foam. It has inlaid leading edge carbon fiber as well as 3mm tube spars. The nose is reinforced with carbon fiber strip as well as backed up with foam wedges. This combination has created the most durable airframe in our fleet. The Quasar is a fully capable 3D airframe great for practicing new maneuvers as well as laid back general flying. With the CG set slightly tail heavy it will hang on the prop literally hands off on the transmitter. The Quasar 3D Delta is a great all around airframe for the beginner pilot as well as advanced, with a full flight envelope for you to enjoy.
Kit Contents:
Airfame:
Carbon
3MM tube
-
1pc) 21-1/2 in Long
-
1pc) 18 in Long
-
1pc) 9-1/8 in Long
3mm X .8 Flat
-
2pcs) 17 in long
-
2pcs) 2-1/2 long
Trussing 1.5mm Solid
Flight Attributes:
-
Hovering ease
-
Smooth flight
-
3D capability
West Michigan Park Flyers Gets You In The Air FASTER!
WMPF does more pre-assembly for you to get you in the air much faster than anyone else in the business! The parts are all cut by CNC laser from 9mm #1.3lb EPP and have alignment tabs for easier building. The kit has of all the foam pieces pre-cut, control surfaces pre-beveled and hinges glued. The aileron servo cutout in the fuselage for a 9 gram servo is pre-cut to speed assembly. The wing spar slot is pre-cut into the bottom of the wing and elevator. The spars are installed for you for all but the foam only kit options. All Hinges and Spars are glued with Beacon Foam Tac Glue.
Note: We are making these kits to order! Kits can take 2-3 days (longer for painted kits) before they are ready for shipping. We run them in batches, so please understand your order may not go out immediately.
Specs:
Recommended setup:
-
Sunny Sky 2204-1480kv motor.
-
9x5DD prop or (APC 9x3.7SF 3D prop)
-
10a to 12a esc.
-
3) 5 gram servos
-
lightweight 4 to 6 channel receiver.
-
2s/300mah to 450mah batteries.
Needed to complete this build:
-
Motor
-
Esc
-
Jst (battery connector)
-
3 servos
-
prop
-
Glue
-
Velcro
